Front edges, rear edges and joints

We are not that square

When choosing a worktop from KUMA, you have a variety of options when it comes to the final finish. Below is a chart of the different edges we can make. Please note that the edges largely depends on the choice of materials.
It you want the chart as a PDF file, it can be downloaded here.

FRONT EDGE

FRONT EDGE	Illustration	Marble	Granite	Granulon	Graphalit	Pearl	Terrazzo	Grasolit	Graphalit Quartz	Graphalit Glass	Rector 12-20mm	Rector 30-250mm
Radius 2 R2 is standard on KUMA + Rector 30-250 mm		•	•	•	•	•	•	•	•	•	•	•
Radius 4		•	•	•	•	•	•	•	•	•	•	•
Radius 10		•	•	•	•	•	•	•	•	•
Floating KUMA 30 mm		•				•	•		•	•
Floating Rector 30 mm												•
2x2 2x2 is standard on Rector 12 og 20 mm											•	•
2 x Radius 6 Kun 12 mm											•
Radius 5 Inclined cut 60< mm												•
Bevel cut 30 mm												•

REAR EDGE

REAR EDGE	Illustration	Marble	Granite	Granulon	Graphalit	Pearl	Terrazzo	Grasolit	Graphalit Quartz	Graphalit Glass	Rector 12-20mm	Rector 30-250mm
Without rear edge		•	•	•	•	•	•	•	•	•	•	•
Rounded rear edge Not possible on sides		•	•	•	•	•	•	•	•	•	•	•
Straight rear edge Also possible on sides (visible glued joints with KUMA materials)		•	•	•	•	•	•	•	•	•	•	•

JOINTS

JOINTS	Illustration
Butt joints Please note that grinding/adaptations are made with a bevel with a radius of approx. 2mm which gives a small recess between the plates.